Figure 12-2 Removing All Components From The Front Of The Sun Fire 6800 System; Figure 12-3 Removing The Bus Bar Access Panels - Sun Microsystems Fire 6800 Service Manual

4. Disconnect all I/O cables.
5. Attach a wrist strap or foot strap. Connect the ESD jack from the system to your
wrist strap or foot strap. Place a grounded ESD mat close to the system.
6. Remove all CPU/Memory boards, Repeater boards, I/O assemblies, System
Controller boards, and filler boards or filler panels from the front and rear of the
system (
FIGURE 12-2
Removing All Components From the Front of the Sun Fire 6800 System
FIGURE 12-2
7. Remove the ID board from the centerplane. See
Board From the Sun Fire 6800
8. Remove the bus bar access panels at the rear of the system.
Removing the Bus Bar Access Panels
FIGURE 12-3
).
System", Step 5.
Section 12.6.1 "Removing the ID
Chapter 12 Centerplane and ID Boards 12-3