Figure 4-6 Removing Or Replacing A Power Supply-Sun Fire 6800 System - Sun Microsystems Fire 6800 Service Manual

3. Loosen the two captive screws (
Ejector lever
Captive screws
FIGURE 4-6
4. Unlock the ejector by pulling the ejector down.
5. Slide the power supply out.
6. If no replacement, install a power supply filler panel to cover the empty slot.
Tighten the captive screws.
4.1.3.2 Installing a Sun Fire 6800 or Sun Fire 4810 System Power
Supply
1. Remove the power supply filler panel if present.
2. Slide the power supply into the slot (
3. Lock the ejector by pushing the ejector up.
4. Tighten the two captive screws.
Note – Install power supply filler panels to cover any empty slots.
5. Make sure that the appropriate power switch on the AC input box for the new
power supply is on.
6. Turn on the power supply using the system controller software.
Refer to the Sun Fire Midrange Systems Platform Administration Manual for complete
procedures for powering on the power supply.
4-8 Sun Fire 6800/4810/4800/3800 Systems Service Manual • May 2008
Removing or Replacing a Power Supply—Sun Fire 6800 System
).
FIGURE 4-6
).
FIGURE 4-6