Figure 10-2 Removing All Components From The Front Of The Sun Fire 6800 System; Figure 10-3 Removing The Bus Bar Access Panels - Sun Microsystems Fire 6800 Service Manual

3. Disconnect all I/O cables.
4. Attach a wrist strap or foot strap. Connect the ESD jack from the system to your
wrist strap or foot strap. Place a grounded ESD mat close to the system.
5. Remove all CPU/Memory boards, Repeater boards, I/O assemblies, System
Controller boards, and filler boards or filler panels from the front and rear of the
system (
FIGURE 10-2
Removing All Components From the Front of the Sun Fire 6800 System
FIGURE 10-2
Note – Do not remove the ID Source board from the centerplane.
6. Remove the bus bar access panels at the rear of the system.
Removing the Bus Bar Access Panels
FIGURE 10-3
).
Chapter 10 Centerplane and ID Source Boards 10-3