Do You Use A Solar Cylinder Module; Set-Up Heating Circuit; Reset Factory Settings - Nefit ModuLine 300 Operating Manual

8.5 Do you use a solar cylinder
module
This function is not applicable. Leave
the factory settings unchanged on
"Nee".
8.6

Set-up heating circuit

This function regulates which heating circuit
must regulate the ModuLine 300.
Setting "0" (Factory setting):
Use this setting, if the ModuLine 300 is the
only thermostat in the installation.
Setting "1, 2, 3 of 4":
Use this setting, if also a ModuLine 400 in the
installation is included and there are several
heating circuits.
(The allocated group must correspond with
the setting on the ModuLine 400)
8.7

Reset factory settings

NOTE!
With this function, all settings from the
service menu (3.1 to 3.6) are reset to
the factory setting.
Technical specifications are subject to change without prior notice.
Operating manual ModuLine 300 • edition 12/2010
Service menu 3.1 – General service-settings
Fig. 42 Solar cylinder module
Fig. 43 Set-up heating circuit
Fig. 44 Reset factory settings
Servicemenu 3.5
--------
Gebruikt u een
zonneboilermodule?
Nee
Servicemenu 3.6
--------
Bij welke cv-groep
hoort
ModuLine 300?
0
Servicemenu 3.1
--------
Servicemenu terug
naar fabrieks-
instellingen?
Nee
8
Nefit B.V. • http://www.nefit.nl
27