Advance Pre-Heating; Button Illumination - Nefit ModuLine 300 Operating Manual

6 Menu 2 – Operating settings
6.4

Advance pre-heating

This function is only applicable if:
– a switch is made from the night
temperature (T1) to a higher
temperature level, e.g. T2, T3, T4;
– the difference between de
measured and set room
temperature is larger than 1 °C.
Advance pre-heating - active
The boiler starts earlier with heating, so that at
the set-up switching point, the desired
temperature already has been reached
(factory setting).
Advance pre-heating - not active
The boiler starts with heating at the set-up
switching point.
6.5

Button illumination

With this function you can turn on or turn off
the button illumination. Symbols are shown in
the display when the button illumination is
turned off. ( page 5).
Nefit B.V. • http://www.nefit.nl
22
Gebruiksmenu
Aanwarmvervroeging in
klokprogramma?
Fig. 32 Advance pre-heating
Gebruiksmenu
Toetsverlichting?
Fig. 33 Button illumination
Technical specifications are subject to change without prior notice.
Operating manual ModuLine 300 • edition 12/2010
2.4
------
actief
2.5
------
aan