Section 4: Adjusting The Transmitter - ProBoat ShockWave 26 EP RS RTR Owner's Manual

Move the speed control on/off switch to the "ON" position
and check for correct operation. The rudder control arm
should move toward the front of the boat when right input
is given. Conversely, when left input is given, the control arm
should move toward the back of the boat.
With the propeller free from any objects, give some throttle
input to ensure that the motor is working. If everything
appears to be functioning correctly, you are ready to run your
boat!
Note: If you are transporting your boat,
make sure you disconnect the battery from
the speed controller and then turn your
radio off until you are ready to run the
boat. Once ready, simply turn the radio
on and plug the battery into the speed
controller, again making sure that the boat
is in neutral.
Left Turn
Left Turn
Section 4: Adjusting
the Transmitter
Note: Refer to the radio instructions for
specific information on transmitter setup.
It may be necessary to adjust the throttle trim knob to stop
the propeller from turning while the throttle trigger is in the
neutral position.
Adjust the rudder trim knob so the rudder is centered prior
to operation. You may adjust this control to make the boat
run straight during operation.
5
Throttle Trim
Steering Trim