THOMSON TG580 Setup And User Manual page 89

On the Wireless Access Point Configure page, you can change the configuration details displayed on the
Details page.
Under Configuration:
Interface Enabled:
To enable the wireless access point, select the check box.
Physical Address:
The physical address or MAC address of the wireless access point (your Thomson Gateway) is static and
can not be configured.
Network Name (SSID):
The network name or SSID of your wireless LAN is by default the SSID of your Thomson Gateway as
mentioned on a label. You can change the name of the SSID by typing a new name in the text box.
Interface Type:
The interface type is the specific wireless standard that must be applied in your wireless LAN. This can
either be (supported interface types depend on Thomson Gateway variant):
802.11b/g
Only stations that are configured in 802.11b or 802.11g mode can associate.
802.11b/g/n
All stations that are configured in 802.11b or in 802.11g or in 802.11n mode can associate.
BandWidth:
The maximum available bandwidth in both up- and downstream direction.
Actual Speed:
Displays the current maximum transmission speed and is not configurable.
Band:
Displays the band in which your Wireless Access Point operates and is not configurable.
Channel Selection:
The channel selection allows you to set the channel selection to Automatic (the Thomson Gateway
selects the channel) or you can set is to Manual. When set to Manual, you can select the channel yourself.
E-DOC-CTC-20090507-0002 v1.0
6 Thomson Gateway GUI
83