P
C
ARKING
ALLS
Replying to a Meet-Me Page
At times other extension users may page you with instructions to meet them
on line (a Meet-Me page). You can go to the nearest endpoint, dial a code,
and be in contact with the paging party.
To reply to a Meet-Me page,
1) Lift handset of the nearest endpoint.
2) Dial 78 and press DIAL/ANSWR.
3) Meet paging party on line.
P
ARKING
You can place an outside call on hold in the system so that it can be
answered from any endpoint even though it does not have a line
appearance for the call.
You do this by placing the call in a park orbit, where it remains until
it is answered, or recalls to the originating endpoint.
Placing an Outside Call in a Park Orbit
1) While on an outside call, press the TRANS/CONF button. The
system places the call on hold.
Note:
programmed Call Park button, you can also press that
button to park the call. Each park button assignment
uses a dedicated park orbit number.
2) If you do not have an assigned Call Park button, enter the Call Park
zone number where you wish to park the call, then press the DIAL/
ANSWR button.
• The default Call Park numbers are *910 through *990. See your
System Administrator for details on getting one of your Edge
300's buttons assigned to this function.
3) The system parks the call in the orbit number you specified.
• Note the assigned park orbit number.
• If you page another user to pick up the call, tell them the orbit
number where they can retrieve the call.
C
ALLS
If your Edge 300 has been assigned a pre-
- 30 -
Edge 300 User Guide