Toyota Tundra 2005 Owner's Manual page 41

Hide thumbs Also See for Tundra 2005:
Table of Contents

Advertisement

WWW.MANUALS.WS
5. Make
sure
that
the
indicator
flashes. Then you may leave the ve-
hicle.
Never leave anyone in the vehicle when
you set the system because unlocking
from the inside activates the alarm.
Activating the alarm
If the system detects a threat to the
vehicle, blows the horn intermittently
for one minute while flashing tail lights
and front side marker lights, and turns
on the interior light.
The system detects a threat under any of
the following conditions:
"
Either of the front doors is unlocked by
means other than the key or remote
keyless entry transmitter.
If the key is not in the ignition switch,
all
the
doors
will
be
automatically
locked again.
"
Any door is forcibly opened.
"
The side windows are tapped or bro-
ken.
"
The battery terminal is disconnected
and then reconnected.
"
The ignition is hotwired.
40
WWW.MANUALS.WS
'05 TUNDRA_U (L/O 0409)
light
After one minute, the alarm automatically
stops and the indicator light starts flashing
again.
Reactivating the alarm
Once set, until you cancel the system, the
system automatically resets the alarm af-
ter the alarm has stopped.
The alarm will activate again under the
same circumstances described in "Activat-
ing the alarm".
Stopping the alarm
You can stop the alarm in either of the
following ways:
"
Unlock any of the doors with the key
or remote keyless entry transmitter.
"
Place the ignition switch in the "ON"
position.
CANCELLING THE SYSTEM
You can cancel the system as described
in "Stopping the alarm".
If you cancel the system by unlocking any
of the doors but no door is opened within
30 seconds, all the doors lock automati-
cally and the system will be set again.
NOTE: If your vehicle's tail lights and
front side marker lights turn on
and the buzzer sounds for 2 sec-
onds when the system is can-
celed, the trigger memory was ac-
tivated; an alarm was triggered
while you were away from the ve-
hicle.
TESTING THE SYSTEM
You can check the system operation as
follows.
1. Open all the windows.
2. Set
the
system
as
described
"SETTING THE SYSTEM".
3. Unlock the driver's door with the inside
lock knob. The system should activate
and the alarm should sound.
4. Stop the alarm as described in "Stop-
ping the alarm".
5. Repeat steps 2 to 4 for the passen-
ger's door.
If the system does not work properly,
have it checked by your Toyota dealer.
2005 TUNDRA from Sep. '04 Prod. (OM34432U)
in

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents