Toyota Tundra 2005 Owner's Manual page 311

WWW.MANUALS.WS
—Garage door opener
310
WWW.MANUALS.WS
'05 TUNDRA_U (L/O 0409)
The garage door opener (
Universal Transceiver) is manufactured
B
under license from HomeLink and can
be programmed to operate
doors, gates, entry doors, door locks,
home lighting systems, and security
systems, etc.
B
(a) Programming the HomeLink
B
The HomeLink in your vehicle has 3
buttons and you can store one program
for each button.
To ensure correct programming into the
B
HomeLink , install a new battery in the
hand- held transmitter prior to program-
ming.
The battery side of the hand- held trans-
mitter must be pointed away from the
B
HomeLink during the programming pro-
cess.
For Canadian users, follow the procedure
in "Programming an entrance gate/pro-
gramming all devices in the Canadian
market".
B
1. Decide which of 3 HomeLink
you want to program. Push and hold
down one of the buttons until the indi-
cator corresponding to the selected
channel begins to flash.
B
2. Place your hand- held garage transmit-
ter 25 to 75 mm (1 to 3 in.) away from
the surface of the HomeLink
garage
Keep the indicator light on the HomeLink
in view while programming.
3. Simultaneously press
hand- held garage transmitter
along with the selected HomeLink
ton.
4. When the indicator
B
HomeLink changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
5. Test the operation of the HomeLink
pressing the newly programmed button.
If programming a garage door opener,
check to see if the garage door opens
and closes.
If the garage door does not operate, iden-
tify if your garage transmitter is of the
"Rolling Code" type. Press and hold the
B
programmed HomeLink
rage door has the rolling code feature if
the indicator light (on the HomeLink
buttons
flashes rapidly and then remains lit after
2 seconds. If your garage transmitter is
the "Rolling Code" type, proceed to the
heading "Programming a rolling code sys-
tem".
2005 TUNDRA from Sep. '04 Prod. (OM34432U)
B
.
B
and hold the
button
B
but-
light on the
B
by
button. The ga-
B
)