Toyota Tundra 2005 Owner's Manual page 190

WWW.MANUALS.WS
3. "4LO" (low speed position,
wheel drive): With the "2WD/4HI"
switch pressed in, push the "4LO"
switch
The "4LO" (low speed four- wheel drive)
indicator light comes on when
"4LO" mode is selected.
Use this for maximum power and trac-
tion. Use "4LO" mode for climbing or
descending steep hills, off- road driving,
and hard pulling in sand, mud or deep
snow.
In this mode, the vehicle stability con-
trol system is off. (See "Vehicle stabil-
ity control system" in this Section.)
See "(c) Shifting procedure" for further
instructions.
WWW.MANUALS.WS
'05 TUNDRA_U (L/O 0409)
(b) A.D.D.
(automatic disconnecting
differential)
four- The A.D.D. can be engaged or disen-
gaged by the shifting operations de-
scribed in "(c) Shifting procedure".
You should drive in four- wheel drive for
at least 16 km (10 miles) each month.
the
This will assure that the front drive com-
ponents are lubricated.
(c) Shifting procedure
SHIFTING BETWEEN "2WD" AND "4HI"
To shift from "2WD" to "4HI", reduce
the vehicle speed to less than 100 km/h
(62 mph) and push in the "2WD/4HI"
switch.
If the "4HI" (high speed four- wheel drive)
indicator light flashes when you push in
the "2WD/4HI" switch, this reminds you
that the transfer mode is not securely in
"4HI" mode. Drive straight ahead while
accelerating or decelerating.
If the "4HI" (high speed four- wheel drive)
indicator light flashes and the buzzer
sounds when you push in the "2WD/4HI"
switch, this reminds you that the transfer
mode is not in "4HI" mode. Reduce the
vehicle speed to less than 100 km/h (62
mph). Push the switch to turn it off, then
once again to turn it back on.
CAUTION
Never push the "2WD/4HI" switch if
the wheels are slipping. Stop the slip-
ping or spinning before shifting.
2005 TUNDRA from Sep. '04 Prod. (OM34432U)
189