Toyota Tundra 2005 Owner's Manual page 205

WWW.MANUALS.WS
—Replacing tires and wheels
When replacing the wheels, be sure to
install air pressure sensors on
wheels.
There are 3 ways to set up the air pres-
sure sensors:
a. Remove the sensor from the old wheel
and install it to the new wheel.
b. Keep the same wheel with air pressure
sensor and replace only the tire.
c. Use a new wheel and sensor. In this
case, you have to register an ID code
for a new sensor.
CAUTION
Have the tires, wheels or sensors re-
placed and ID codes registered by a
Toyota dealer. If you need sensors,
purchase from a Toyota dealer.
204
WWW.MANUALS.WS
'05 TUNDRA_U (L/O 0409)
the
TIRE PRESSURE WARNING
RESET SWITCH
The tire pressure warning system need
to be initialized in the following condi-
tions:
"
After replacing or rotating tires or
wheels
"
After replacing an air pressure sen-
sor.
When initializing the system, the pres-
ent tire condition is stored as a stan-
dard.
To initialize the system, perform the fol-
lowing:
1. Park the vehicle at a safe place and
apply the parking brake. Stop the en-
gine.
2. Adjust the pressure of all the installed
tires to the specified level. (See "Tires"
in Section 8.)
3. Turn the ignition key to "ON".
4. Push and hold the reset switch until
the low tire pressure warning light
blinks three times.
Initialization is completed over for more
SYSTEM
than 20 minute.
2005 TUNDRA from Sep. '04 Prod. (OM34432U)