Toyota Tundra 2005 Owner's Manual page 312

WWW.MANUALS.WS
6. Repeat steps 2 through 5 for each re-
B
maining HomeLink button to program
another device.
Programming a rolling code system
If your device is "Rolling
equipped, it is necessary to
steps 1 through 4 under the heading
B
"Programming the HomeLink " before
proceeding with the steps listed below.
1. Locate the "training" button on the ceil-
ing mounted garage door opener motor.
The exact location and color of the
button may vary by brand of garage
door opener. Refer to the owner's
guide supplied by the garage door
opener manufacturer for the location of
this "training" button.
2. Press the "training" button on the ceil-
ing mounted garage door opener motor.
Following this step, you have 30 seconds
in which to initiate step 3 below.
WWW.MANUALS.WS
'05 TUNDRA_U (L/O 0409)
3. Press and release the vehicle's pro-
B
grammed HomeLink
garage door may open. If the door
does open, the programming process is
complete. If the door does not open,
Code"
press and release the button a third
follow
time. This third press and release will
complete the programming process by
opening the garage door.
The ceiling mounted garage door opener
motor should now
B
HomeLink unit and be able activate the
garage door up/down.
4. Repeat steps 1 through 3 for each re-
B
maining HomeLink button to program
another rolling code system.
Programming an entrance gate/program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
tons you want to program.
2. Place your hand- held
transmitter 25 to 75 mm (1 to 3 in.)
away from the surface
B
HomeLink .
Keep the indicator light on the HomeLink
in view while programming.
3. Press and hold
B
HomeLink button.
4. Continuously press and release (cycle)
button twice. The the hand- held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the
B
HomeLink
rapid flash after 20 seconds, you can
release both buttons.
6. Test the operation of the HomeLink
pressing the newly programmed button.
recognize the
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink
another device.
Programming other devices
To program other devices such as home
security systems, home door locks or
B
but-
lighting, contact your authorized Toyota
dealer for assistance.
gate/device
Reprogramming a button
Individual HomeLink
of the
erased, however, to reprogram a single
button, follow the procedure "Programming
B
B
the HomeLink
the selected
2005 TUNDRA from Sep. '04 Prod. (OM34432U)
indicator light on the
changes from a slow to a
B
by
B
button to program
B
buttons cannot be
".
311