Battery - SMART For two coupé Operator's Manual

Screw the end of filler hose ? onto tire
X
valve G.
Insert electrical plug B into the aux-
X
iliary power outlet (
Insert the key in the starter switch and
X
turn it to position 1.
i
The vehicle's battery is drained by use
of the electric air pump. You should
therefore keep the engine running — in
the open air — while inflating the tire.
Press I on electric air pump switch C.
X
The electric air pump is switched on and
inflates the tire.
i
First, the sealant is pumped into the
tire. The pressure may briefly increase
to a high value. This is normal and not an
indication of a malfunction. Do not
switch off the electric air pump.
Let the electric air pump inflate the tire
X
for a maximum of ten minutes.
Pressure gauge ; must display at least
180 kPa (1.8 bar, 26 psi).
page 114).
Y
! Do not operate the electric air pump
longer than ten minutes without inter-
ruption. Otherwise it may overheat.
You may operate the electrical air pump
again after it has cooled off.
If a tire inflation pressure of at least
X
180 kPa (1.8 bar, 26 psi) is not attained,
turn off the electric air pump by press-
ing 0 on electric air pump switch C.
Unscrew the end of filler hose ? from
X
tire valve G.
After clearing the area around the vehi-
X
cle of people and obstacles, drive vehi-
cle back or forth very slowly approx-
imately 30 ft (10 m).
This serves to better distribute the tire
sealant material inside the tire.
Screw the end of filler hose ? onto tire
X
valve G.
Inflate the tire again.
X
G
WARNING
If a tire inflation pressure of
180 kPa (1.8 bar, 26 psi) is not attained, the
tire is too severely damaged for the tire
sealant to provide a reliable tire repair.
In this case, the tire sealant cannot prop-
erly seal the tire.
Do not drive the vehicle.
Contact the nearest smart center for assis-
tance or call Roadside Assistance.
After attaining a tire inflation pressure
X
of at least 180 kPa (1.8 bar, 26 psi), press
0 on electric air pump switch C.
The electric air pump is switched off.
Turn the key in the starter switch to
X
position 0.
Unscrew the end of filler hose ? from
X
tire valve G.
Plug filler hose with the stopper.
X
Tire sealant container E remains
X
screwed onto flange F.
Flat tire
189
Z