High-Beam Flasher; High-Beam Headlamps; Coming Home Function; Turn Signals - SMART For two coupé Operator's Manual

High‑beam headlamps and high-beam
flasher
Make sure the low‑beam headlamps are
X
switched on ( page 65).
Y
Switching on: Push the combination
X
switch to position 1.
The high‑beam headlamps come on.
The high‑beam headlamp indicator lamp
K in the instrument cluster comes on.
Switching off: Pull the combination
X
switch in direction of arrow ; to its
original position.
The high‑beam headlamps go out.
The high‑beam headlamp indicator lamp
K in the instrument cluster goes out.
High-beam flasher: Pull the combination
X
switch briefly in direction of arrow ;.

Turn signals

Turn signals, right
:
Turn signals, left
;
Vehicles with rain-light sensor*.
9
* optional
Switching on: Push the combination
X
switch in direction of arrow : or ;.
The corresponding turn signals flash.
The corresponding turn signal indicator
lamp # or ! in the instrument
cluster flashes.
The combination switch resets automat-
ically after major steering wheel move-
ment.
i
To signal minor directional changes
such as changing lanes, push the combi-
nation switch only to the point of resist-
ance and release. The corresponding turn
signals will flash three times.

Coming home function

Vehicles without rain-light sensor: The
interior lamps come on and then go out
again after 12 seconds every time when you
lock or unlock the vehicle.
Vehicles with rain-light sensor*: In addi-
tion to the interior lamps, the exterior
lamps come on and then go out again after
12 seconds depending on the brightness of
the ambient light when you lock or unlock
the vehicle.
When leaving the vehicle
Remove the key from the starter switch.
X
Exit the vehicle.
X
Press button * on the key.
X
The vehicle is locked.
The interior and exterior
and then go out again after 12 seconds.
When returning to the vehicle
Press button # on the key either once or
X
twice.
The vehicle is either selectively or
globally unlocked.
Lighting
67
9
lamps come on
Z