Care And Maintenance; Direction Of Rotation, Spinning; Inspection; Service Life - SMART For two coupé Operator's Manual

Tires and wheels
134
For more information on tire load rating
( page 137).
Y
For information on calculating total and
cargo load capacities (
Direction of rotation
Unidirectional tires offer added advan-
tages, such as better hydroplaning per-
formance. To benefit, however, you must
make sure the tires rotate in the direction
specified.
An arrow on the sidewall indicates the
intended direction of rotation (spinning)
of the tire.
Tire care and maintenance
G WARNING
Regularly check the tires for damage. Dam-
aged tires can cause tire inflation pres-
sure loss. As a result, you could lose control
of your vehicle.
Worn, old tires can cause accidents. If the
tire tread is badly worn, or if the tires have
sustained damage, replace them.
Check the tire inflation pressure at least
once a month. For more information on
checking tire inflation pressure, see
"Recommended tire inflation pressure"
( page 125).
Y
Tire inspection
Every time you check the tire inflation
pressure, you should also inspect your
tires for the following
excessive treadwear (
R
cord or fabric showing through the tire's
R
rubber
bumps, bulges, cuts, cracks or splits in
R
the tread or side of the tire
Replace the tire if you find any of the above
conditions.
page 131).
Y
page 134)
Y
Life of tire
G WARNING
Tires should be replaced after 6 years,
regardless of the remaining tread.
The service life of a tire is dependent upon
varying factors including but not limited
to
driving style
R
tire inflation pressure
R
distance driven
R
Tread depth
G WARNING
Although the applicable federal motor
vehicle safety laws consider a tire to be
worn when the treadwear indicators (TWI)
become visible at approximately
(1.6 mm), we recommend that you do not allow
your tires to wear down to that level. As
tread depth approaches
adhesion properties on a wet road are
sharply reduced.
Depending upon the weather and/or road
surface (conditions), the tire traction var-
ies widely.
Do not allow your tires to wear down too far.
Adhesion properties on wet roads are
sharply reduced at tread depths of less
1
than / in (3 mm).
8
Treadwear indicators (TWI) are required by
law. These indicators are located in six
places on the tread circumference and
become visible at a tread depth of approx-
1
imately / in (1.6 mm), at which point the
16
tire is considered worn and should be
replaced.
Recommended minimum tire tread depth:
1
Summer tires / in (3 mm)
8
1
Winter tires / in (4 mm)
6
1
/ in
16
1
/ in (3 mm), the
8