SMART For two coupé Operator's Manual page 125

clockwise to release any excess pres-
sure.
Continue turning pressure cap : coun-
X
terclockwise and remove it.
The coolant level is correct if the level
for cold coolant: reaches marking
R
bar ; visible through the filling
opening
for warm coolant: is approximately
R
0.6 in (1.5 cm) higher
If necessary, add coolant.
X
Adding coolant
Add coolant as required. The coolant
X
level may not exceed the maximum filling
level.
Replace and tighten pressure cap :.
X
Remount the service flap and close it
X
( page 120).
Y
Windshield/rear window washer system
Both the windshield and the rear window
washer are supplied from the windshield
washer reservoir.
The recommended minimum filling level is
1.06 US qt (1.0 l).
Remove the service flap and insert it on
X
the front of the vehicle (
The windshield washer reservoir is located
in the front compartment on the driver's
side.
Coupé only.
14
G
Windshield washer concentrate is highly
flammable. Fire, naked flames and smoking
are prohibited when windshield washer
concentrate is being handled.
X
X
! Always use a windshield washer concen-
14
X
page 120).
Y
X
X
X
X
Front compartment
WARNING
Use a windshield washer concentrate
labeled for summer and water for tem-
peratures above freezing point.
Use a windshield washer concentrate
labeled for winter and water for temper-
atures below freezing point.
trate labeled for winter where tempera-
tures may fall below freezing point.
Failure to do so could result in damage
to the washer system/reservoir.
Premix the windshield washer fluid in a
suitable container.
Observe mixing ratios depending on the
outside temperature (
Use the tab to pull cap : upwards.
Refill the windshield washer reservoir.
Push cap : onto the windshield washer
reservoir.
Remount the service flap and close it
( page 120).
Y
page 222).
Y
Z
123