SMART For two coupé Operator's Manual page 185

Left bulb carrier with bulb sockets (right bulb
carrier in reverse)
Retaining tab
:
Brake, tail, turn signal and side marker
=
lamp bulb
Backup lamp bulb
?
Depending on which bulb needs to be
X
replaced, press gently onto bulb =
or ? and turn it counterclockwise.
Pull the bulb out of the bulb socket.
X
Installing: Insert the new bulb into the
X
bulb socket.
Press gently onto the bulb and turn it
X
clockwise until it engages.
Insert the bulb carrier into the tail lamp
X
housing.
Press gently onto the bulb carrier.
X
Let retaining tab : engage.
Fold the damping material backward, if
X
necessary.
Reinstall the side cover in the cargo
X
compartment.
High-mounted brake lamp
Removing: Unscrew retaining screws :.
X
Remove high-mounted brake lamp ?.
X
Detach electrical connector ; from bulb
X
socket =.
Turn the bulb counterclockwise and pull
X
it out of its socket.
Installing: Install in the reverse order.
X
License plate lamps
G WARNING
High outside temperature, stop-and-go
traffic, driving on long uphill grades, or
driving at high engine speed may increase
the temperature in the engine compart-
ment. Therefore the area around the air
slots in the rear apron may be hot. Let the
engine cool off before touching this area
to prevent burns.
Replacing bulbs
Z
183