Illumination; Introduction - SMART For two coupé Operator's Manual

Control system*
92
! Do not hang any objects on the tachom-
eter.
This could cause the tachometer to be
torn from its mountings and damage it.
Cockpit clock*
The cockpit clock can be turned by approx-
imately 90°.
The cockpit clock illumination comes on
when you switch on the ignition and the
exterior lighting.
The buttons for setting the time are on the
top of the cockpit clock.
Setting the time back in 1 minute incre-
X
ments: Press button : repeatedly until
the desired time is set.
Setting the time back quickly: Press but-
X
ton : for longer than two seconds.
The setting speed accelerates.
Setting the time forward in 1 minute
X
increments: Press button ; repeatedly
until the desired time is set.
Setting the time forward quickly: Press
X
button ; for longer than two seconds.
The setting speed accelerates.
! Do not hang any objects on the cockpit
clock.
This could cause the cockpit clock to be
torn from its mounting and damage it.
Adjusting instrument cluster illumi-
nation
You can adjust the illumination of the
switches, the dials in the instrument clus-
ter, the radio*, the climate control* panel
and the auxiliary instruments*. Five illu-
mination levels are available.
Make sure the key is in starter switch
X
position 1.
Switch on the parking lamps.
X
To brighten or dim illumination: Press
X
button : on the instrument cluster
repeatedly until the desired setting is
reached.
The current setting is stored.
Control system*

Introduction

The control system is activated when you
turn the key in the starter switch to posi-
tion 1.
G WARNING
A driver's attention to the road and traffic
conditions must always be his/her primary
focus when driving.
In order to avoid distraction which could
lead to an accident, the driver should
select features and change settings in the
control system only vehicle at a standstill
or when traffic and road conditions permit
it to be done safely.
* optional