Husqvarna BZ 27 Operator's Manual page 60

LUBRICATION
The oil level shall lie between the markings
on the dipstick. If the level is approaching the
"ADD" mark, top up the oil to the "FULL" mark
on the dipstick.
Never fill above the "FULL" mark.
The oil is filled through the hole for the
dipstick.
8009-159
The dipstick markings
Use engine oil SAE 30 or SAE 10W-30 or,
alternately, 10W/40, class CF–4, CI-4
(over +32 °F/0 °C).
Over +68 °F /+20 °C SAE 40 can be used.
Use engine oil SAE 5W-20, class CF–4, CI-4
(under +32 °F/0 °C).
The engine holds 3.5qt/3.3 liters of oil
including the filter.
8009-140
Engine oils
4. Throttle Cable, Lever Bearings
Lubricate the cable ends by the lever with an
oil can. Move the controls to the end points
and lubricate again.
The throttle cable is also lubricated by the
control when the control console is removed.
8011-605
Throttle and choke cables by the carburetor
5. Front Wheel Mount
Lubricate with a grease gun, one zerk for
each wheel mount, use 10 pumps of the
grease gun at the recommended service
intervals. Use only good quality lithium based
grease.
Use only good quality molybdenum
disulphide grease.
58
English-