Husqvarna BZ 27 Operator's Manual page 33

5. On power units push the hydraulic lift
switch froward to lower the deck to the
selected pin position.
WARNING!
Make sure that no one is near
the machine when engaging
the blade switch.
6. Engage the mower deck by pulling out
the blade switch.
7. Move the throttle control to full throttle.
8. The machine's speed and direction are
continuously variable using the two
steering controls. When both controls are
in the neutral position, the machine
stands still.
By moving both controls an equal
amount forward or backward, the
machine moves in a straight line forward
or backward respectively.
In order, for example, to turn right while
moving forward, move the right control
towards the neutral position. The rotation
of the right wheel is reduced and the
machine turns to the right.
Turning on the spot can be achieved by
moving one control backward (behind the
neutral position) and carefully moving the
other steering control forward from its
neutral position.
NOTE: The direction of the zero turn will be
determinded by which lever is pulled back
beyond neutral. Thus left lever back, left zero
turn and opposite for right zero turn. Use
extra care when using this maneuver the
machine can spin very rapidly if one lever
is positioned too far ahead of the other.
NOTE: To begin motion, the operator must be
in the seat and the parking brake disengaged
before the motion control levers can be
moved from the neutral slots or the engine
will kill.
OPERATION
Hydraulic switch
Engaging the mower deck
BAM-2
BAM-2
31
English-