Sharp AX-1100J Operation Manual page 27

TROUBLESHOOTING CHART
The following situations are normal and are not signs that the oven is malfunctioning.
QUESTION / SITUATION
The display is black / blank.
Control panel /
power supply
The display is fi ne but Instant
Cook/START will not function
when pressed.
E l e c t r i c a l p o w e r s u p p l y i s
interrupted during cooking.
The display does not change
Energy save
to blank.
mode
Leakage of water from the
Water
bottom front of the oven.
* Open the door and close.
* Check the power plug is properly connected to a
suitable wall outlet.
* Check that fuse or circuit breaker are functioning
properly.
* Disconnect the power cord, wait for a minute. Then
reconnect, open and close the door.
* Open the door and close. Is the oven light off? Press
Instant Cook/START again.
* If the message "Err, HOT (fl ashing)" is displayed, wait
until the message has disappeared.
The programmed cooking time and mode will be
cancelled.
Continue to cook with manual mode.
In the following cases, Energy Save Mode
will be cancelled temporarily:
- When the door is opening.
- Pause of the automatic cooking.
- When the cooking fan is working after cooking.
- Demonstration mode
- Child lock
- Extend mode
- Drain mode
- Descaling mode
- Kitchen timer mode
- When the display shows "Err, WATER (fl ashing)".
- When Clock is set.
* Check the drip tray is installed correctly. Remove and
replace the drip tray correctly.
See page 8.
* Did you empty the drip tray before the cooking? You
must empty the drip tray and replace it before Steam
Cooking will start. See page 8.
24
ANSWER