Kitchen Timer; Instant Cook; Info - Sharp AX-1100J Operation Manual

OTHER CONVENIENT FEATURES

Kitchen Timer

Use the Kitchen Timer as a minute timer or to monitor
the standing time for cooked/defrosted food.
* Suppose you want to set the kitchen timer for 5
minutes.
P R O C E D U R E
1
Enter the desired time.
2
Press Info/Timer once.
NOTE:
In Energy Save Mode, open and close the door to
activate Kitchen Timer before entering the desired
time.

Instant Cook

Instant Cook allows you to operate the two following
functions:
a) Direct start
You can directly start cooking on 100% Microwave
power for 1 minute by pressing Instant Cook/START.
NOTE:
To avoid the misuse by children Instant Cook/START
can be used only within 3 minutes after preceding
operation, i.e., closing the door, pressing the Stop/
Clear key or cooking completion.
b) Extend the manual cooking time
You can extend the manual cooking time for multiples
of 1 minute if Instant Cook/START is pressed while
the oven is in operation.
NOTE:
You can not use this function for Steam cooking.
The cooking time can be extended up to 99 minutes.

Info

Info key provides 7 features.
In F1: Drain
In F2: Descale
In F3: Water Hardness
In F4: Demo
In F5: Child Lock
In F6: Clock
In F7: Energy Save Mode
The number from "In F1" to "In F7" will be displayed
when you select the feature.
These features can be selected by pressing Info/
Timer and the desired function number and pressing
Instant Cook/START.
DRAIN
The remaining water inside the steam generator can
be evaporated by using the DRAIN function. See
page 10.
DESCALE
See page 10.
WATER HARDNESS
Your oven is set at the factory to water hardness
setting 2 (hard). You can set the oven for the water
hardness level.
You can use a test strip available at some drug
stores, to check the water hardness level.
In some areas, it is possible to ask the water supply
company for the water hardness.
When you use test strips, follow the instructions of
them.
Hardness level Hardness range
<120 ppm
1
<120 mg/l
<6.7 °dH
120 - 250 ppm
2
120 - 250 mg/l
6.7 - 14.0 °dH
>250 ppm
3
>250 mg/l
>14.0 °dH
P R O C E D U R E
Press Info/Timer and the number 3 to select
1
Water Hardness. "In F3" will be displayed then
the preset hardness level will be displayed.
2 Press desired hardness level number and
press Instant Cook/START.
The water hardness setting will be held in the
memory even if the oven power is off.
20
Setting
Soft
Hard
Very hard