Led Behavior - HP 2510-24 Installation And Getting Started Manual

Installing the Switch
Installation Procedures
2.

LED Behavior:

2-10
Check the LEDs on the switch as described below.
Switch port LEDs
*
Spd mode: off = 10 Mbps,
ProCurve Switch
1 3
Link Mode
2510-24
J9019A
Power
Fault
Act
Locator LED
Mode
FDx
*
Test Spd
2 4
Reset Clear Link Mode
Console
Power, Fault
Test LED
and locator
LEDs
When the switch is powered on, it performs its diagnostic self test. Self
test takes approximately 50 seconds to complete.
During the self test:
• Initially, all the status, LED Mode and port LEDs are on for most of
the duration of the test.
• Most of the LEDs go off and then may come on again during phases
of the self test. For the duration of the self test, the Test LED stays on.
When the self test completes successfully:
The Power LED remains on.
•
The Fault and Test LEDs go off.
•
• The port LEDs on the front of the switch go into their normal opera-
tional mode:
– If the ports are connected to active network devices, the LEDs
behave according to the LED Mode selected. In the default view
mode (Link), the LEDs should be on.
– If the ports are not connected to active network devices, the LEDs
will stay off.
If the LED display is different than what is described above, especially if
the Fault and Test LEDs stay on for more than 60 seconds or they start
blinking, the self test has not completed correctly. Refer to chapter 4,
"Troubleshooting" for diagnostic help.
ProCurve Switch 2510-24 (J9019A)
flash = 100 Mbps, on = 1000 Mbps 10/100Base-T Ports (1 - 24) — Ports are HP Auto MDI-X
5 7 9 11 13
Link Mode
6 8 10 12 14
Link Mode
Link
15 17 19 21 23
Link
25
16 18 20 22 24
M