Lower Oven Control Compartment Access (Double Wall Oven); Cooling Fan; Door Hinge Receivers - Monogram ZET1PL1SS Technical Service Manual

Cooling Fan

A cooling fan is located above each oven in the
center rear wall of the control compartment. In a
double wall oven, both fans operate together.
The fan(s) will begin to operate at approximately
200°F (oven cavity) to cool the internal components.
The fan(s) may continue to operate even after
the oven is turned off and will cease operating at
approximately 350°F.
The fan motor in the single and upper oven is a 2
speed motor and has an approximate resistance
value of:
Red to white = 33 Ω
Black to white = 27 Ω
Red to black = 6.3 Ω
The fan motor in the lower oven is a single speed
motor and has an approximate resistance value of
67 Ω.
The cooling fan(s) can be removed from the front of
the oven.
To remove the cooling fan in the single and upper
oven:
1. Access the control compartment. (See
Compartment Access
2. Using a long extension, remove the four ¼-in.
hex-head screws that hold the cooling fan to the
rear wall of the control compartment.
3. Disconnect the cooling fan wire harness.
Cooling Fan
Control
.)
4. Carefully remove the cooling fan from the
control compartment.
To remove the cooling fan in the lower oven:
1. Access the lower oven control compartment.
(See
Lower Oven Control Compartment Access.)
Note: For added accessibility, it may be helpful to
remove the relay board metal bracket from the
lower oven. (See
Power Supply and Relay Board
2. Using a long extension, remove the four ¼-in.
hex-head screws that hold the cooling fan to the
rear wall of the control compartment.
3. Disconnect the cooling fan wire harness.
4. Carefully remove the cooling fan from the
control compartment.

Door Hinge Receivers

To remove the door hinge receivers:
1. Remove the side access panels. (See
)
Removal.
2. Carefully lift the insulation from the outside of
the oven.
3. Remove the 4 T-15 screws (2 on each side) that
hold each hinge receiver to the oven frame.
Note: Upon reassembly, ensure displaced insulation
around oven and components is returned to it's
original position.
– 37 –
.)
Oven