Advertisement
Single Oven Cutout
A4
for Installation Over
a Monogram Warming
Drawer
Per Warming
Drawer
Requirement
1" (2.5 cm) Min. Above Toekick or
Adjust to Oven Installation Height
NOTE: Additional clearances between cutouts
may be required. Check to be sure the oven
supports above the Warming Drawer location
do not obstruct the required interior depth and
height.
Cutout for Frameless Cabinets
A6
Frameless Cabinets
Whenever possible, order 30" (76.2 cm)
frameless cabinet with the cutout sided to fit
the oven. If using stock cabinets, additional
finished filler pieces may be required to
cover the opening.
• A stock frameless cabinet cutout width
may be up to 28 3/4" (73 cm). If necessary,
add 1/2" (1.3 cm) cleats to the sides, flush
with the front edge of the side panels to
accept mounting screws.
Cabinetry
A5
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement
2" (5.1 cm) Min.
NOTE: Install the
oven only with
specific models
listed on the label
located on top of
the oven.
• When installing a Monogram Warming
Drawer below a single or double oven, a
separate 120V, 60 Hz, properly grounded
receptacle must be installed. Refer to
installation instructions packed with the
Warming Drawer for specific installation
requirements.
7
Double Oven Cutout
for Installation Over
a Monogram Warming
Drawer
Per Warming
Drawer
Requirement
1" (2.5 cm) Min. Above Toekick
Install 1/2"
(1.3 cm)
Cleats to
Hold Oven
Mounting
28 1/2" (72.4 cm)
Screws
28 5/8" (72.7 cm)
Double
51 15/16" (131.8 cm)
Single
27 5/16" (69.2 cm)
Anti-Tip Block
Against Rear
Wall Per
Warming
Drawer
Requirement
2" (5.1 cm)
Min.
30"
(76.2 cm)
Cabinet Depth
23 1/2" (59.7 cm)
Min.
Min. From Inside
Back to Front of
Max.
Cabinet Frame
or Side Panel
3/4" (1.9 cm) Min.
Thick Bottom Shelf
Cut Back Flush
with Front of
Side Panel
Advertisement
