Convection Bake Element; Convection Fan Assembly - Monogram ZET1PL1SS Technical Service Manual

Convection Bake Element

• The convection bake element is composed of an
inner and an outer element. It is replaced as one
unit.
• The inside element is rated at 900 watts, has
an approximate resistance value of 62 Ω, and
draws approximately 3.9 amps.
• The outside element is rated at 1600 watts, has
an approximate resistance value of 35 Ω, and
draws approximately 6.9 amps.
• The convection bake element is located on the
back wall of the oven and can be removed from
inside the oven cavity.
To remove the convection bake element:
1. Remove oven racks. (See
2. Remove the four ¼-in. hex-head screws that
hold the convection cover to the back wall of the
oven cavity.
3. Remove the three ¼-in. hex-head screws that
hold the convection bake element to the back
wall of the oven cavity.
.)
Oven Racks
– 28 –
4. Carefully pull the convection bake element
towards the front of the oven until the element
terminals are accessible.
Convection Bake Element
IMPORTANT: The lower wattage inner element
/
utilizes -in. terminal connections. The higher
3
16 16
wattage outer element utilizes ¼-in. terminal
connections.
5. Disconnect the wires from the convection bake
element.

Convection Fan Assembly

The convection fan assembly is located on the
back wall of the oven cavity and consists of the
fan guard, blade, insulation, and motor. The fan
motor utilizes a capacitor that can be accessed
from the component compartment. (See
.) The convection fan assembly can be
Locator Views
removed from inside the oven.
The convection fan operates during the following
modes:
• Preheat
• Convection Bake
• Convection Broil
• Convection Roast
• Proof
• Clean
Component
(Continued Next Page)