Special Features - Monogram ZET1PL1SS Technical Service Manual

Special Features

Special
Your oven has additional Special Features that you
may choose to use.
features of
your oven They remain in the control's memory until
the steps are repeated. The Special Features
control
will remain in memory after a power failure.
Either the Oven Mode knob and/or the
Temperature knob must be turned
to OFF.
Oven
You may find that your new oven cooks differently than
the one it replaced. Use your new oven for a few weeks to
thermostat
become more familiar with it. If you still think your new
adjustment
oven is too hot or too cold, you can adjust the thermostat
yourself.
To adjust the oven thermostat:
1 Push and hold the PROBE and DELAY START
buttons at the same time for 4 seconds until the
display shows SF (Special Features).
2 Push the PROBE button. A "0" will show in the
display.
On double wall oven models, a "0" will show in
both the upper and lower oven displays. Push the
PROBE button a 2nd time ("UPPER" will show in
the display) to set the upper oven, and push PROBE
a 3rd time ("LOWER" will show in the display) to
set the lower oven.
3 Turn the Mini-Knob to adjust the oven
thermostat up to 35°F hotter or (-) 35°F cooler
in 1°F increments.
4 Push the Mini-Knob to enter your choice.
Tones at
At the end of a timed cycle, 3 short beeps will sound
followed by one beep every 6 seconds until the TIMER
the end of a
button is pushed. This continuous 6-second beep may be
timed cycle
cancelled. To cancel the 6-second beep:
1 Push and hold the PROBE and DELAY START
buttons at the same time for 4 seconds until the
display shows SF (Special Features).
2 Push the TIMER button to choose between:
con SF bEEP – Continuous Beeps – Reminder
beeps will sound after a timed cycle has ended
until the TIMER button is pushed.
SF bEEP – No beeps – The reminder beeps
after a timed cycle is cancelled.
3 Push the Mini-Knob to enter your choice.
4 Push and hold the Mini-Knob for 5 seconds
to exit SF (Special Features) and return to the
time of day clock.
On double oven models, either the Oven Mode knob or
the Temperature knob will have to be turned to OFF for
each oven.
NOTE: While in the Special Features mode, if the
Mini-Knob is not pushed to enter a choice after 60
seconds, the mode will be cancelled (without changes)
and the time of day will return to the display.
The following are the features and how you
may activate them.
Double oven display shown.
2. Push to choose.
1. Push and hold at the same time to enter/exit SF.
5 Push and hold the Mini-Knob for 5 seconds
to exit SF (Special Features) and return to the
time of day clock.
Do not use thermometers, such as those found in
grocery stores, to check the temperature setting of
your oven. These thermometers may vary 20–40
degrees.
NOTE: This adjustment will only affect baking
temperatures; it does not affect broiling, convection
or self-cleaning temperatures. The adjustment will
be retained in memory after a power failure.
Double oven display shown.
2. Push to choose.
1. Push and hold at the same time to enter/exit SF.
NOTE: On double oven models, this cancels the
end-of-cycle tone for both ovens.
– 10 –
3. Mini-
Knob
Push to
enter choice
3. Mini-
Knob
Push to
enter choice
(Continued next page)