Control Compartment Access - Monogram ZET1PL1SS Technical Service Manual

Control Compartment Access

Note: It may be necessary to partially remove the
oven from the installation to avoid damage to the
customer's woodwork. (See
To access the control compartment:
1. Open oven door.
2. Remove the three ¼-in. hex-head screws that
attach the bottom of the control panel to the
vent trim.
Note: The control panel has keyhole slots at the top
and is held very tight to the side trims.
3. Carefully push the control panel up, then pull out
at the bottom.
4. Mark and disconnect wire harnesses from the
control panel.
Caution: Wire harnesses connecting the mode
and temperature encoders can be incorrectly
reconnected. Make sure wire harnesses are
connected properly.
.)
Oven Removal
Lower Oven Control Compartment Access
(Double Wall Oven)
To access the lower compartment:
1. Remove the upper oven door. (See
.)
Assembly
2. Remove the 2 Phillips-head screws from the top
of the middle trim.
3. Open the lower oven door.
4. Remove the three ¼-in. hex-head screws from
the bottom of the middle trim. Remove the trim.
5. Remove the four ¼-in. hex-head screws
that attach the cross member to the front
of the control compartment. Remove the
crossmember.
6. If necessary, remove the three ¼-in. hex-head
screws that attach the vent trim to the front of
the cabinet. Remove the trim.
– 30 –
Door
Middle Trim
Screws