Oven Racks - Monogram ZET1PL1SS Technical Service Manual

To remove the FAD:
The FAD is held in place by two ¼-in. hex-head
screws. To access the FAD on a single or upper
oven, see
Control Compartment Access
oven, see
Lower Oven Control Compartment Access
To remove the single or upper oven power vent
assembly and FAD:
1. Remove the racks. (See
2. Access the control compartment. (See
.)
Compartment Access
3. Remove the three ¼-in. hex-head screws that
attach the vent trim to the oven. Remove the
vent trim.
4. Disconnect the left side light wire harness.
5. Disconnect the power vent wire harness.
Power Vent
. On the lower
.)

Oven Racks

Control
Disconnect
Disconnect
Note: Two holes are provided in the broiler shield to
gain access to the 2 screws that attach the power
vent assembly to the oven frame.
6. Remove the two ¼-in. hex-head screws that
. attach the power vent assembly to the oven
frame.
7. Lift and remove the power vent assembly.
To remove the lower oven power vent assembly
and FAD:
1. Remove the ovens from the installation and
separate the ovens. (See
2. Remove the three ¼-in. hex-head screws from
the bottom of the middle trim.
3. Remove the three ¼-in. hex-head screws that
attach the vent trim to the oven. Remove the
vent trim.
4. Disconnect the power vent wire harness.
Note: Two holes are provided in the broiler shield to
gain access to the 2 screws that attach the power
vent assembly to the oven frame.
5. Remove the two ¼-in. hex-head screws that
attach the power vent assembly to the oven
frame.
6. Lift and remove the power vent assembly.
– 39 –
.)
Oven Removal