Transporting Cleaner; Handle Positions - Hoover Vacuum Cleaner Owner's Manual

Cord Transporting
Rewind Cleaner
Grasp the end
2-4 2-5
of the plug
and pull to
release cord
from cord
reel. After
desired cord
length is
reached, the
A
cord will lock
into position.
To move your cleaner
To return cord for storage, hold plug
from room to room,
and press on button (A) at top of cord
put handle in upright
reel. To prevent cord from whipping,
position, tilt cleaner
hold plug until cord is rewound.
back on rear wheels
and push forward.
Carpet Height
Adjustment Settings
The cleaning
2-7 2-8
of carpet and
rugs takes
place at the
A nozzle (A).
When it is
B
necessary
to raise and
lower the
nozzle for
pile carpet, where easier pushing effort is desired, while
various carpet pile heights, turn
maintaining good cleaning performance.
the nozzle control knob (B) to the
desired setting.
Agitator Brush Roll Shut-Off
The agitator brush roll shuts off automatically for tool use,
2-9
when the cleaner is in the upright position.
B
A
To manually shut off the agitator brush roll for cleaning hard
floors, step on the pedal (A). The indicator (B) will show red
in the "brush roll off" window. To turn the agitator brush roll
on, step on the pedal again. The indicator will show red in the
"brush roll on" window.
Handle
Positions
The handle
2-6
of your
cleaner
has three
1
2
positions;
upright for
storage and
when using
3
cleaning
tools;
operating
position for general operation on
carpet and floors; low for reaching
under low furniture. Step on handle
release lever to lower handle.
For maximum cleaning performance,
the following carpet height settings
are recommended:
• Lowest setting: for all types of
carpet.
Note: If the cleaner is difficult to
push, turn knob to the next higher
setting.
• Higher settings: for very deep
6