Agitator Brush Roll; Powered Hand Tool - Hoover Vacuum Cleaner Owner's Manual

Agitator Brush Roll

Disconnect cleaner from electrical outlet.
WARNING: Agitator brush roll can start suddenly. Unplug cleaner before turning it over.
Replacing Agitator Brush Roll
When agitator brushes are worn, the brush roll should be replaced.
Inspecting Agitator Brush Roll
To check condition of
4-19
brushes, move edge of a
card across bottom plate
while turning agitator
brush roll. To maintain
cleaning effectiveness,
replace agitator brush
roll if brushes do not
touch card.
Positioning V-Belt
Insert agitator brush
4-21
roll through belt and
position belt in groove
(A) on agitator brush roll.
A
Agitator Brush Roll: What to Buy
When purchasing a new Agitator Brush Roll, ask
for HOOVER part No. 93002361.

Powered Hand Tool

Replacing Agitator Brush Roll
When agitator brushes are worn, the brush roll should be replaced.
How to Replace
Turn tool so bottom
4-23
faces up. Press the
latches on either side of
tool and remove bottom
plate (A).
A
Removing Agitator Brush Roll
Turn carpet height
4-20
adjustment knob to
lowest setting. Turn
cleaner over and remove
bottom plate (Fig. 4-13).
Lift up agitator brush
roll and slide V-belt (A)
off agitator brush roll.
A
Installing Agitator Brush Roll
4-22 Grasp agitator brush
roll firmly and fit it into
position by first sliding
end opposite the belt into
the rectangular slot (A)
on side of cleaner.
Pull other side of agitator
brush roll (B) into place.
B
Belt may fit loosely when
A
properly installed.
Reposition flat belt and bottom plate (Figs. 4-15
to 4-16).
4-24
Unscrew the two Phillips screws and remove
belt guard (A).
12
A