Removing/Installing Batteries From/Into Battery Tray - Invacare Pronto M71 Owner's Operator And Maintenance Manual

Batteries with terminal configuration as shown below MUST be used. Batteries
that have the reverse terminal configuration MUST NOT be used - otherwise
injury and damage may occur.
Terminals MUST have a cross hole in them as shown below
Use This Configuration
U1 Battery

Removing/Installing Batteries from/into Battery Tray

Always use the battery handle or lifting strap when lifting the battery. It is the most
convenient method and assures that the battery acid will not spill. It also helps to
prolong the life of the battery.
DO NOT tip the batteries. Keep the batteries in an upright position.
NOTE: For this procedure, refer to FIGURE 18.2.
NOTE: Have the following tools available:
TOOL
7/16-INCH (6PT) BOX WRENCH
DIAGONAL CUTTERS
Part No 1141449
WARNING
NEGATIVE (-)
Battery Terminal
NEGATIVE (-)
Battery Terminal
Cross Holes
POSITIVE (+)
Battery Terminal
FIGURE 18.1 Using the Proper Batteries
WARNING
Do Not Use
QTY
1
1
83
SECTION 18—BATTERIES
POSITIVE (+)
Battery Terminal
U1 Battery
COMMENTS
Not Supplied
Not Supplied
® ™
Pronto M71 with SureStep
™