Adjusting Footrest Height; On Phwh93 Front Riggings; On Ph904A And Phal4A Front Riggings - Invacare Pronto M71 Owner's Operator And Maintenance Manual

Adjusting Footrest Height

on PHWH93 Front Riggings

NOTE: For this procedure, refer to FIGURE 16.2.
1. Remove any accessory from the footrest(s).
2. Remove the footrest from the wheelchair. Refer to Installing/Removing Front Riggings
on page 70.
NOTE: Lay footrest on a flat surface to make hardware more accessible.
3. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the
footrest support.
4. Reposition the lower footrest to the desired height.
5. Reinstall hex bolt, coved washers and
locknut that secure lower footrest to
footrest support. Tighten securely.
6. Repeat STEPS 1-5 for the opposite side
of the wheelchair footrest, if necessary.
7. Reinstall the footrest(s) onto the
wheelchair. Refer to Installing/
Removing Front Riggings on page 70.
8. Reinstall any accessory onto the
footrest(s).

on PH904A and PHAL4A Front Riggings

NOTE: For this procedure, refer to For this
procedure, refer to FIGURE 16.3.
1. Loosen, but do not remove, the lug bolt
and locknut that secure the lower
footrest to the footrest support.
2. Reposition the lower footrest to the
desired height.
3. Securely tighten the lug bolt and
locknut that secure the lower footrest to
the footrest support.
4. Repeat STEPS 1-3 for the opposite side
of the wheelchair footrest, if necessary.
Part No 1141449
SECTION 16—FRONT RIGGINGS
Locknut
Coved Washer
FIGURE 16.2 Adjusting Footrest Height -
on PHWH93 Front Riggings
Footrest
Support
Lug Bolt
NOTE: PH904A style front rigging
shown. PHAL4A front rigging adjust the
same way.
FIGURE 16.3 Adjusting Footrest Height -
on PH904A and PHAL4A Front Riggings
71
Footrest Support
Coved Washer
Hex Bolt
Lower Footrest
Locknut
Lower
® ™
Pronto M71 with SureStep
™