Installing/Removing Batteries Into/From Battery Boxes - Invacare 3G Storm Series Torque ST User Manual

9 SETUP/MAINTENANCE

9.10 Installing/Removing Batteries Into/From Battery Boxes

 For this procedure, refer to FIGURE 3 on page 101.
If there is battery acid in the battery boxes or on the sides of the battery, apply baking soda to these areas to neutralize the
battery acid. Before reinstalling the existing or new battery, clean the baking soda from the battery boxes or battery being
sure to avoid contact with skin and eyes. Determine source of contamination. NEVER install/reinstall a battery with a
cracked or otherwise damaged case.
When securing battery lifting strap to battery, observe polarity markings located on the ends of the battery lifting strap, (+)
side to POSITIVE (+) battery post and (-) side to NEGATIVE (-) battery post.
To remove the batteries from the battery boxes, reverse the following steps.
Have the following tools available:
1/2-INCH (6PT) BOX WRENCH
BATTERY LIFTING STRAP
Invacare 3G Storm Series®
TOOL QTY
1
1
100
COMMENTS
Not Supplied
Not Supplied
Part No 1143151