Removing/Installing Batteries From/Into Battery Tray - Invacare Pronto M51 Base Owner's Operator And Maintenance Manual

Base with surestep formula cg tilt, rehab seating
Hide thumbs Also See for Pronto M51 Base:
Table of Contents

Advertisement

Removing/Installing Batteries from/into Battery Tray

ALWAYS use the battery handle when lifting the battery. It is the most convenient
method and assures that the battery acid will not spill. It also helps to prolong the
life of the battery.
DO NOT tip the batteries. Keep the batteries in an upright position.
NOTE: For this procedure, refer to FIGURE 9.2 on page 54.
NOTE: If there is battery acid in the bottom of the battery tray or on the sides of the battery, apply 
baking soda to these areas to neutralize the battery acid. Before reinstalling the existing or new 
battery, clean the baking soda from the battery tray or battery being sure to avoid contact with skin 
and eyes. Determine source of contamination. NEVER install/reinstall a battery with a cracked or 
otherwise damaged case.
NOTE: Have the following tools available:
TOOL
7/16-INCH (6PT) BOX WRENCH
DIAGONAL CUTTERS
Removing
1. Place the wheelchair in a well ventilated area where work can be performed without 
risking damage to carpeting or floor covering.
2. Verify the joystick On/Off switch is in the Off position and disconnect joystick cable 
(not shown). Refer to Disconnecting/Connecting the Joystick on page 121.
3. Perform one of the following:
• Tilt the seat assembly to the up position. Refer to Tilting the Seat Assembly 
(Formula CG Only) on page 41.
• Remove the seat assembly from the wheelchair. Refer to Removing/Installing the 
Seat Assembly on page 43.
4. Remove the battery shroud. Refer to Removing/Installing the Battery Shroud on 
page 47.
5. Disconnect the front battery from the controller (BLACK connector). 
6. Disconnect the rear battery from the front battery (RED and BLACK connectors).
7. Lift rear and front battery out of the battery tray using the battery handles.
Installing
1. Verify the joystick On/Off switch is in the Off position and disconnect joystick cable. 
Refer to Disconnecting/Connecting the Joystick on page 121.
Part No. 1148076
WARNING
QTY
1
1
53
SECTION 9—BATTERIES
COMMENTS
Not Supplied
Not Supplied
®
Pronto
M51
Base with SureStep
®

Advertisement

Table of Contents
loading

Table of Contents