Section 15-Footboard Assembly; Removing/Installing The Footboard Assembly; Removing; Installing - Invacare Pronto M71 Owner's Operator And Maintenance Manual

SECTION 15—FOOTBOARD
ASSEMBLY
After ANY adjustments, repair or service and BEFORE use, make sure that all
attaching hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, verify that ON/OFF
switch on the joystick is in the OFF position.
DO NOT stand on the flip-up footboard. When getting in or out of the wheelchair,
make sure that the flip-up footboard is in the upward position.
LIMITED CLEARANCE BETWEEN FOOTBOARD AND CASTER - The user's feet
MUST remain on the footboard while operating the wheelchair. If the user's feet
are allowed to rest off the side of the footboard they may come in contact with the
caster possibly resulting in injury.

Removing/Installing the Footboard Assembly

NOTE: For this procedure, refer to FIGURE 15.1.

Removing

1. Remove the quick release pin that secures the footboard assembly to the wheelchair
frame by depressing the button while sliding the pin out.
2. Remove the footboard assembly from the wheelchair frame.

Installing

Make sure the detent balls of the quick release pin are fully released and protruding
past the outer edge of the tube before operating the wheelchair. Otherwise, injury
and/or damage may result.
Keep detent balls clean.
1. Position the footboard assembly onto the wheelchair frame so that the mounting holes
in the wheelchair frame align with the desired mounting holes in the footboard
assembly.
2. Install the quick release pin by depressing the button while sliding the pin In. Make
sure the detent balls are fully released and protruding past the outer edge of the tube.
Part No 1141449
SECTION 15—FOOTBOARD ASSEMBLY
WARNING
WARNING
67 ® ™
Pronto M71 with SureStep
™