Replacing The Cutting Unit Belts; Service Position For Cutting Unit; Placing In Service Position - Husqvarna 155, 155 AWD Operator's Manual

Belt replacement on the cutting unit
On these cutting units with "collision-proof" blades,
the blades are driven by one V-belt. Do as follows to
change the V-belt:
1. Remove the cutting unit, see page 38.
2. Undo the bolt on the lift strut and the two screws
on the cover. Lift the cover off the cutting unit.
3. Loosen the spring that tensions the V-belt and
pry off the belt.
Simply reverse the procedure to fit the new belt.
Service position for the cutting unit
The cutting head can be placed in the service
position to provide easy access for cleaning, repairs
and servicing. In service position, the cutting unit is
raised and locked in the vertical position.

Placing in service position

1. Position the machine on flat ground. Apply the
parking brake (A). Adjust the cutting unit to the
lowest cutting height and lower the cutting unit
(B).
2. Remove the front hood by removing the pin.
(There are complete instructions on using the
service position inside the front hood).
MAINTENANCE
8009-287
6012-080
8009-437
6021-006
43
English –