Main Fuse; Checking The Tyre Pressure; Checking The Engine's Cooling Air Intake - Husqvarna 155, 155 AWD Operator's Manual

Main fuse

The fuse is located in a loose holder under the
battery case cover, in front of the battery.
Type: Flat-blade mounting, 15 A.
Do not use any other type of fuse when replacing.
A blown fuse indicates that the mounting has burnt
off. Pull the fuse out of the holder when replacing.
The fuse is used to protect the electrical system. If
it blows again shortly after replacing this is due to a
short circuit, which must be rectified before the
machine is used again.
Checking the tire pressure
The tire pressure should be 60 kPa (0.6 kp/cm
all round.
To improve driving the pressure on the rear tires
can be reduced to 40 kPa (0.4 kp/cm
The maximum tire pressure is 100 kPa
(1.0 kp/cm 2 /14 PSI).
IMPORTANT INFORMATION
Different tyre pressures on the front tyres
will result in the blades cutting the grass
at different heights.
Check the engine's cooling air intake
Clean the air intake grille in the engine cover
behind the driver's seat.
Fold open the engine cover.
Check that the cooling intake is free from leaves,
grass and dirt.
Check the air duct, located on the inside of the
engine cover, ensure it is clean and does not rub
against the cooling air intake.
If the cooling intake is blocked this will interfere with
the cooling of the engine, which can damage the
engine.
WARNING!
The cooling air intake rotates
when the engine is running. Mind
your fingers.
MAINTENANCE
2 /8.5 PSI)
2 /5.6 PSI).
Air intake grille
Cooling air intake
8009-370
6008-030
8009-431
8009-470
39
English –