Servicejournal - Husqvarna 155, 155 AWD Operator's Manual

Work done
Pre-delivery service
1. Top up battery with acid and recharge for four hours.
2. Fit steering wheel, seat and any optional equipment.
3. Adjust cutting unit:
Adjust the lifting springs (the "weight" of the cutting unit should
be 12-15 kg/26.5-33 lbs). Only applies to BioClip.
Adjust cutting unit so that rear edge is about 2–4 mm/1/8"
higher than front edge.
Adjust cutting unit height setting so that cutting height limit is
5 mm/3/16" above the frame of the unit at the lowest cutting
height.
4. Check that engine has correct amount of oil.
5. Check that the right amount of oil is in the transmission.
6. Check and adjust tyre pressure (60 kPa/0.6 bar/8.5 PSI).
7. Connect battery.
8. Fill with fuel and start engine.
9. Check that machine does not move in neutral.
10. Check:
Forward drive.
Reverse drive.
Operation of blades.
Seat safety switch.
Lift lever safety switch.
Safety switch for the hydrostat pedals.
11. Check engine revs 2 900±100rpm.
12. Check the screws on the muffler. (10Nm)
13. Tell customer about:
Need and benefits of following the service schedule.
The need and advantages of leaving the machine for regular
service.
The effects of maintenance on the machine's second hand
value.
Range of applications for BioClip.
14. Complete proof of sale, etc.
After first 5 hours
1. Change engine oil.

SERVICEJOURNAL

Date, mileage, stamp, sign
Pre-delivery service carried out.
No outstanding problems.
Certified:
55
English –