Adjusting The Parallelism Of The Cutting Unit; Removing The Cutting Unit - Husqvarna 155, 155 AWD Operator's Manual

Adjusting the parallelism of the cutting
unit
1. Remove the front hood and the right-hand
fender, as described on page 21.
2. Undo the nuts on the lift strut.
3. Screw out (extend) the stay to raise the rear
edge of the cover.
Screw in (shorten) the stay to lower the rear
edge of the cover.
4. Tighten the nuts after adjustment.
5. On completion of the adjustment the unit's
parallelism should be re-checked.
6. Fit the right-hand fender and the front hood.

Removing the cutting unit

WARNING!
Wear protective glasses when
dismantling the cutting unit. The
spring which tensions up the belt
can go off and cause personal
injury.
1. Carry out points 1-9 to put the cutting unit in the
service position, see "Service position for the
cutting unit" on page 33.
2. Remove the bolt (3) and lift off the cutting unit.
Fitting of the cutting unit takes place in the reverse
order to removal.
When assembling: Make sure that the unit's "lug"
enters the loop correctly on the underside of the
machine.
42
– English
MAINTENANCE
1
6017-018
2
3
6017-021
8009-123