Installation; Unpacking; Mounting Guidelines - Briggs & Stratton Automatic Transfer Switch Installation & Operator's Manual

Home generator systems 200 amp automatic transfer switch with ac power control module
Table of Contents

Advertisement

Available languages

Available languages

Installation

Unpacking

Delivery Inspection
After removing the carton, carefully inspect the transfer
switch components for any damage that may have occurred
during shipment.
IMPORTANT: If loss or damage is noted at time of delivery,
have the person(s) making delivery note all damage on the
freight bill and affix his signature under the consignor's
memo of loss or damage. If loss or damage is noted after
delivery, contact the carrier for claim procedures. Missing or
damaged parts are not warranted.
Shipment Contents
• Automatic Power Transfer Switch
• Installation and Operator's Manual
• Current Transformers
Typical
— — — — — — Control Wiring
Hot Water
Heater
Alternate
— — — — — — Control Wiring
Hot Water
Heater
6
Contactor
Main
Breaker
Panel
Branch Circuits
Disconnect Switch
Contactor
Emergency
Load Center
Emergency
Branch Circuits

Mounting Guidelines

The Automatic Transfer Switch is enclosed in a NEMA
Type 3R enclosure suitable for indoor/outdoor use.
Guidelines for mounting the Automatic Transfer Switch
include:
• Install the switch on a firm, sturdy supporting structure.
• The switch must be installed with minimum NEMA 3R
hardware for conduit connections.
• To prevent switch contact distortion, level and plumb the
enclosure. This can be done by placing washers between
the switch enclosure and the mounting surface.
• NEVER install the switch where any corrosive
substance might drip onto the enclosure.
• Protect the switch at all times against excessive moisture,
dust, dirt, lint, construction grit and corrosive vapors.
A typical installation of the Automatic Power Transfer Switch
is depicted below. An alternative installation of the Automatic
Power Transfer Switch is also depicted below. It is best if the
transfer switch is mounted near the utility meter, either
inside or outside. Discuss layout suggestions/ changes with
the owner before beginning the system installation process.
Service Disconnect
Transfer
Switch
Generator
Conditioner
Transfer
Main
Switch
Breaker
Panel
Disconnect Switch
Air
Conditioner
Watt -
Hourmeter
Air
Watt -
Hourmeter
Branch
Circuits
Generator
BRIGGSandSTRATTON.COM

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents