Intermec EasyCoder PM4i User Manual page 17

Problems and Possible Solutions (continued)
Problem
When I try to set RFID
MODE to ENABLE, I get
one of these error messages,
• "Error in filename"
(Fingerprint or Intermec
Direct Protocol)
• "No RFID support"
(IPL)
None of the RFID
commands work, and
I get this message "RFID
Inactive."
Printing on regular media
(not RFID) is slow and
halted in between labels.
I am using an application
to write to RFID tags, and
the printer is printing
"VOID" labels.
When I try to perform a
TESTFEED, I get this
message, "No tag found."
I get this error message,
"Not supported by tag
type." (Fingerprint)
EasyCoder Printer (PM4i, PX4i, and PX6i ) RFID User's Guide
Possible Solution
An RFID kit is not installed in the printer. For
help, contact your local Intermec representative.
RFID MODE is disabled. Change MODE to
ENABLE. For help, see
page 11.
RFID MODE is enabled. Change MODE to
DISABLE. For help, see
page 11.
• The printer may not recognize the RFID
media type. For Fingerprint printers, run a
TESTFEED. For IPL printers, raise and lower
the printhead, and then press Feed or turn
on the printer.
• You may need to modify the TAGADJUST
parameter. For help, see
"RFID,TAGADJUST" on page
• You may need to adjust the output power to
the antenna. For help, see
"RFID,FIELDSTRENGTH" on page 16
• Make sure that you are using RFID media.
• You may need to modify the TAGADJUST
parameter. For help, see
"RFID,TAGADJUST" on page
• The tag may be broken. Try printing on a
different label.
This error message indicates that a command:
• may be trying to access a tag data segment
that is not available on the RFID media.
• is being used with a level of security that is
not allowed by the tag type.
Make sure that you are using the appropriate
media for your application.
"RFID,MODE" on
"RFID,MODE" on
12.
12.
17