Using The Printer's Home Page; Using Fingerprint Commands - Intermec EasyCoder PM4i User Manual

SETUP:
RFID
RFID:
MODE
MODE:
ENABLE
MODE:
DISABLE
IPL RFID Setup Tree
3 Configure the RFID parameters. For more information, see

Using the Printer's Home Page

1 Make sure you have an EasyLAN Ethernet card installed in
2 Find your printer's IP address:
3 On your PC, run your web browser application.
4 In the address field, enter your printer's IP address. The
5 From the main menu, select Configuration.
6 Select Printer > RFID.
7 Configure the RFID parameters. For more information, see

Using Fingerprint Commands

You can use Fingerprint commands to configure the RFID
parameters. For example, the following code sets TAGADJUST to
50 dots, RETRIES to 3 labels. and VOIDTEXT to "Bad label".
SETUP "RFID,TAGADJUST,50"
SETUP "RFID,RETRIES,3"
SETUP "RFID,VOIDTEXT,Bad label"
For more details about RFID parameters, see
Parameters" on page
10
These menus are only displayed when an RFID module is installed.
RFID:
TAGREAD
TAG:
Read-Only
"RFID Parameters" on page
your printer.
a On your printer console, press Setup.
b Navigate to Network > IP Address.
Or,
• On your printer console, press the
printer's home page appears.
"RFID Parameters" on page
EasyCoder Printer (PM4i, PX4i, and PX6i ) RFID User's Guide
RFID: RFID:
TAGADJUST RETRIES
RETRIES:
TAGADJUST:
[1]:
[0]:
11.
11.
11.
RFID: RFID:
VOIDTEXT FIELDSTRENGTH
FIELDSTRENGTH:
VOIDTEXT:
[72]:
[VOID]:
Read-Only
or button.
"RFID