Using Ipl Commands; Rfid Parameters - Intermec EasyCoder PM4i User Manual

Using IPL Commands

You can use IPL commands to configure the RFID parameters.
Example 1:
<SI>Jn,m,p,q
where: n
Example 2:
<SI>Kn
where n is the VOIDTEXT string.

RFID Parameters

This section describes the RFID parameters.
RFID,MODE
Set this parameter to ENABLE (default) to use RFID commands.
RFID,RETRIES
Specifies the number of tags the printer tries to access after a
failed attempt to read or write to a tag.
Valid values are a number from 0 to 10 (default = 1).
The printer prints the text string specified by the VOIDTEXT
parameter before trying to access the next tag. If all retries fail,
the printer positions the current label below the antenna and
display an error. For more information about errors, see
"Troubleshooting" on page
RFID,VOIDTEXT
Specifies the text to print on labels with faulty tags. VOIDTEXT
can only be configured from the printer's home page or by using
a Fingerprint or IPL command.
Valid values are up to 16 characters (default = VOID). You can
also enter an empty string as "".
The text is printed so that it is centered on the label, uses the
Swiss 721 Bold BT font, and covers 80% of the label width.
EasyCoder Printer (PM4i, PX4i, and PX6i ) RFID User's Guide
is 1 for RFID,MODE,ENABLE
is 0 for RFID,MODE,DISABLE
m is the TAGADJUST value in dots
p is the number of RETRIES.
q is the FIELDSTRENGTH.
16.
11