Omega CA450 User Manual page 22

Display (LCD) Description
Symbol or Unit Description
Appears during DC measurement or output
Appears during AC measurement
Appears when the polarity is negative (minus)
Appears during diode test mode
Appears during continuity check mode
Appears when relative values are being displayed
Indicates that the measurement range is set to fixed
Indicates that the measurement range is set to auto
Indicates the present range
Appears when data hold is enabled
Appears when auto hold is enabled
Appears when peak hold is enabled
Appears when the MIN, MAX, and AVG values are being
measured
Appears when the MAX value is being displayed
Appears when the MIN value is being displayed
Appears when the AVG value is being displayed
Appears when user calibration is being performed
Appears when the auto power-off function is enabled
Appears during rms value detection
Appears when SHIFT has been pressed
Shows the main value
Shows the input or output value
A converted value is shown in SENSOR mode
Indicates the main unit
Indicates the subunits
Shows the MIN, MAX, and AVG recording time
Shows the input voltage unit in SENSOR mode
Shows the subvalue
Shows the MIN, MAX, and AVG recording time
Shows the reference value during relative calculation
20