Table of Contents
Advertisement
Sets or queries whether the mode is normal mode or calibration
SY
mode
Command = SYm<CRLF> -> Answer = SYm<CRLF>
Command = SY?<CRLF> -> Return = SYm<CRLF>
Parameters
m = 0: Normal mode (default)
Increases the m
UP
Command = UPm<CRLF> -> Answer = UP,OK<CRLF>
Parameters
m = 1 to 5 (1 is the least significant digit while 5 is the most
significant digit)
If the CA450 is in any mode other than constant current output
mode, ERR13 is returned.
If the CA450 is in span check mode, ERR13 is returned.
Increases the output value by one step or sets the output value
UQ
to 100%
Command = UQ<CRLF> -> Answer = UQ,OK<CRLF>
Increases the output value by one step (25%).
Sets the output value to 100% of the span in span check mode.
If the CA450 is in any mode other than constant current output
mode, ERR13 is returned.
1: Calibration mode
th
digit of the output value by 1
7
Normal Cal.
Normal Cal.
Î
Normal Cal.
Î
Advertisement
Table of Contents
