HighPoint RocketRAID 432x User Manual page 13

2.2 – Installing the RocketRAID 4322 Host Adapter
Note: Make sure the system is powered-off before installing the RocketRAID 4322
host adapter.
1. Installing the
HighPoint Ethernet Board – the
HighPoint Ethernet Board
U1 is the RJ45 connector. J1 is connector for connecting the HighPoint Ethernet
Board to the RocketRAID Host Adapter. If you want to use the Ethernet functions,
connect the HighPoint Ethernet Board to the RocketRAID Host Adapter via connec-
tors J4 through J1, and secure the two boards to the bracket. If you do not want to
use the Ethernet function, secure the RocketRAID Host Adapter to the bracket.
1. Open the system chassis and locate an unused PCI-Express x8.
2. Remove the PCI slot cover.
3. Gently insert the RocketRAID 4322 into the PCI-Express slot, and secure the
bracket to the system chassis.
4. Close and secure the system chassis
Hardware – Description and Installation
following illustration shows the
.
13