Crosscutting - Husqvarna 315, 320 Operator's Manual

CAUTION!
If the chain becomes stuck in the kerf, STOP THE SAW!
Do not attempt to jerk the saw free. You could be harmed by the chain if the saw
suddenly comes loose. Lever the saw free instead.
• Cutting a log on the ground. There is little danger of the saw jamming or
the log splintering, but it is difficult to avoid running the saw into the ground
when breaking through at the end of the cut.
Saw straight through the log. Be careful at the end of the cut to avoid contact
with the ground. Keep the saw running at full speed, but be prepared for the
breakthrough.
- If it is possible to turn the log, stop cutting 2/3 of the way through the log.
- Turn the log and cut the remaining section from above.
• Cutting a log supported at one end. The log is more than likely to splinter if
cut straight through from the top down.
- Make an initial cut from below (approx. 1/3 of the diameter).
- Finish the cut from above.
• Cutting a log supported at both ends. The saw is more than likely to jam in
the kerf if cut straight through from above.
- Make an initial cut from the top (approx. 1/3 of the diameter).
- Finish the cut from below.

CROSSCUTTING

19