Page 1
2x1 DVI DL Switcher U S E R M A N U A L www.gefen.com...
Page 2
Woodland Hills, CA 91367-9897 Notice Gefen Inc. reserves the right to make changes in the hard ware, packaging and any accompanying doc u men ta tion without prior written notice. 2x1 DVI DL Switcher is a trademark of Gefen Inc.
TABLE OF CONTENTS Introduction Features Panel Desciptions Connecting and Operating the DL Switcher Operation Notes RMT2-IR Installation IR Extender Installation Specifi cations Warranty...
Our Commitment Gefen will always offer the fi nest quality product at the best possible price. Included in that price is a lifetime of free support from a team of outstanding engineers. Now you can switch easily and reliably between any combination of two dual link DVI &...
• Switch between two dual link DVI, USB 2.0 and Audio Sources • IR Remote control • Rackmountable Includes: 2x1 DVI DL Switcher One 5v Power Supply One RMT2-IR Remote Control Two 6ft Dual Link DVI cables Two 6ft USB cables...
Page 6
PANEL DESCRIPTIONS Power Indicator Infrared Indicates which Selecter Eyes input is selected Equalizations Knobs Contact Closure Interface - Connects to optional wired Audio In 1 Audio In 2 Audio Out RMT-2 remote control DVI In 1 DVI In 2 5VDC Input DVI Out Output USB In 1...
Page 7
Connecting and Operating the 2x1 DVI DL Switcher How to Connect the DL Switcher to your devices 1- Connect the supplied cables from your fi rst computer into the DVI In 1, USB In 1, and Audio In 1 connection in the back of the DVI Switcher.
When turning on or rebooting your computers, the DVI DL Switcher must be selected to the computer that is booting until the computer completes the boot cycle. This step can be eliminated using the Gefen DVI Detective. If you loose your picture when switch from source 1 to source 2 or viasaversa you will need a DVI Detective.
RMT2-IR Installation 1. Remove battery cover from the back of the RMT2-IR remote. 2. Verify that dip switches 1 & 2 are in the down (OFF) position. 3. Insert the battery, hold the battery so that you can see the positive side facing up. The side that is not marked must be facing down.
IR Extender Installation How to Connect the IR Extender 1 Open the unit and move the jumper labeled INFRARED (pictured* as "Step 1" below) from Local to Remote 2 In the bank of switches labeled SERVICE SWITCH (pictured* as "Step 2" below), fl ip Service Switch #1 (top most switch) to the ON position 3 Reassemble the unit.
SPECIFICATIONS Video Amplifi er Bandwidth ................2x 1.65 Gbps Input Video Signal ..................1.2 volts p-p Input DDC Signal .................. 5 volts p-p (TTL) Single Link Range ..................3840 x 2400 DVI Input/Output Connector Type ........ DVI-I 29 pin female (digital only) USB 2.0 Input Connection ..................
If equipment fails because of such defects and Gefen Inc. is notifi ed within one (1) year from the date of shipment, Gefen Inc. will, at its option, repair or replace the equipment, provided that the equipment has not been subjected to mechanical, electrical, or other abuse or modifi...
Page 13
6265 Variel Avenue Woodland Hills, CA 91367 1-800-545-6900 818-884-6294 fax: 818-884-3108 www.gefen.com gsinfo@gefen.com...